Required Pool Pump Maintenance Tips

Required Pool Pump Maintenance Tips: Continue Your System Easily

With the heat compensation and the pool season begins, many homeowners are preparing to dive back to Oasis in their previous verandah. However, one of the most common and disappointing problems is finding that the pump pump is not working properly. (Onga Hammerhead Pool Cleaner)

Here are some essential pool pump maintenance tips, to help you avoid surprise and increase the lives of your devices.

General Safety and Cleaning

1. Always close the power before maintenance

Before clearing air inlets or maintaining any, be sure to turn off the power. This guarantees your safety and prevents damage to the motor.

2. Don't panic about heat

While running, pool pump motors can be heated, which does not mean they work overly. Class B insulated motors can work at temperatures up to 133º C. As long as the empire remains within the limits and the automatic protector does not travel, the motor is operating properly.

Seasonal Storage Tips

3. Protect the motor during the passive period

When the pump is not used for an extended period, especially in -sone:

• To avoid the rust, let all the surfaces, vents and interior dry.

• Store the motor in a dry area or protect it against snow, dirt and leaves if it covers it.

4. Wet the pump seal before restarting

Before turning the pump back after a long break, make sure the suction is flooded so that the pump seal is wet. Starting the engine with a dry seal can damage it.

Cleaning and Lubrication

5. Just clean the exterior

The interior of the motor usually does not require cleaning if it is protected with sand, lint and dirt. To clean:

• Use a damp cloth for the exterior.

• Never spray the engine from a hose - fluiding is reversible damage.

6. Lubrication and bearings

Most pool pumps have double sealed, permanently grease bearings. If the bearings fail (often indicated by unusual noise), replace them immediately to avoid overheating and further damage. The engine needs minimal maintenance if kept in a clean, dry and well-ventilated environment.

Preventive Tips for Longevity

7. Look for moisture

Leaks from the pipe joints or seals can lead to failure or insulation failure. Always repair the leaks immediately, and keep the pump dry. Establish it from low, wet areas and protect it from rain and wind.(hayward pool pump)

8. Ensure the rotation of proper air

To keep the motor cool:

• Maintain space around the motor for ventilation.

• Keep air inlets clear with dust and debris.

• Clean the inlets regularly - but only when the power is off.

• Make sure the motor cover allows the airflow and does not trap moisture.

9. Replace the seal from the bearings

If you are replacing the bearings because of the sound, change the pump seal as well. Noisy bearings often indicate a leaking seal, and prevent both recurring problems from replacing.

Contact of Chemical and Dirt

10. Keep the chemicals away

Never store pool chemicals near the engine. Their emissions can cause internal rust and premature damage.

11. Avoid cleaning while running

Do not clean or disturb the dust around the engine when it is working, as this can introduce particles to the system.

Ultimate Ideas

These guidelines are crucial to maintain the efficiency of your pool pump and enhance its service life. If it's too late and your pump is already showing signs of failure, don't worry - we have covered you. Visit our pool pump section to find a full replacement for your needs.